Product composition

Thimble_clevis

Thimble clevis, bolt,
nut and split pin

dead-end component

Dead-end component

Protection splice

Protection splice

Mounting protection splice

Монтаж протектора

Male sure the mounting point is clean. Match the middle marking of the protection splice strand with the cable.
Wind the protector on the cable to the both sides.

Монтаж протектора

Repeat the process with the rest of the strands.

Монтаж протектора

In the middle point the protection splice should fully cove the cable in a solid layer.

Монтаж протектора

Complete winding the strands in the direction of the clevis thimble first, then in the opposite. If the strands are too tight at the ends to wind manually, a screwdriver can be used with precaution in order not to damage the cable.

Монтаж протектора

Cutting pliers can be used to split glued wires apart and wind them individually.

Монтаж протектора

After mounting is complete it is advisable to make sure that all wires lie tightly and none of them come out over the layer.

Mounting the dead-end component

Монтаж зажима

The dead-end is mounted so that 15-20 cm of protection splice is left in the direction of the tower.
Apply the marking of the dead-end component to the protection splice and wind 2-3 turns of the strand.
Insert the clevis thimble into the loop and wind the other strand.

Монтаж зажима

After that both strands are wound to the whole length simultaneously. At the end of the mounting cutting pliers can be used to split the wires apart and wind them individually.

 

Address

© SARMAT LLC
430001, Russia, Republic of Mordovia,
Saransk, Stroitelnaya, 3
Tel. / fax.  +7 8342 480928
e-mail: sale@sarmatura.ru